Re: 9A lever collet closer - spindle pin


Bob Kellermann
 

When I set my 10 k up very similar To 9  make sure there is a positive grip in the handle or else whatever you have in the Collett will slip under pressure check the split bronze bushing for the handle 
Also after you adjust the collet take sure you tighten the Allen key in back wheel 

On Jul 1, 2020, at 2:13 PM, Larry Shaw <larry@...> wrote:

Further to Bill’s comments on the 4th photo, the 14th photo is a section through the headstock which shows the collet sleeve very close to the spindle.

Join SouthBendLathe@groups.io to automatically receive all group messages.