Re: 1949 SB 16/24 USAF Lathe


I am sure this document is in the files section but I am attaching. I think it will provide some information.

On Apr 24, 2020, at 2:50 PM, Matt R <mrissmiller@...> wrote:

My 16/24 has a foot on the tailstock end. How do I go about leveling and getting the twist out of the bed? Can I just do all levelling at the headstock end? Currently it is sitting on rubber pad (hockey pucks). 1 under each of the 2 bolt bosses on the headstock end and 3 under the foot at the tailstock end.

Jim B.

Jim B

Join to automatically receive all group messages.