Re: Southbend 9" lathe table in CONCRETE?


Steven H
 

Here is a photo of what appears to be a concrete lathe bench with an Atlas-Craftsman lathe on top. Not my lathe, just a photo I found on-line some time back. Personally I think it's overkill. But concrete is relatively inexpensive so knock yourself out should you choose to go this route. Good luck.

Regards,
Steven R. Haskell
 

-----Original Message-----
From: ww_big_al <arknack@...>
To: SouthBendLathe <SouthBendLathe@groups.io>
Sent: Fri, Dec 27, 2019 3:53 pm
Subject: Re: [SouthBendLathe] Southbend 9" lathe table in CONCRETE?

I don’t know about a lathe table, but I do fill my grinder pedestal stands with either concrete or sand. That dampen vibrations a lot.
Al
 
From: SouthBendLathe@groups.io <SouthBendLathe@groups.io> On Behalf Of Steven Schlegel
Sent: Friday, December 27, 2019 11:12 AM
To: SouthBendLathe@groups.io
Subject: [SouthBendLathe] Southbend 9" lathe table in CONCRETE?
 
With all of the discussions about lathe tables, I have to ask:  What is your opinion about making one out of concrete?  I have heard they are very dead (no spring) so makes turning a lot easier.  As I approach putting my 1940 SB 9” A and C lathes into operation, I am planning ahead for the tables.
 
Steven

Join SouthBendLathe@groups.io to automatically receive all group messages.