Re: Heavy Ten conversion to L00


John Dammeyer
 

Ah. So if you just loosened the nut you're still left with the chuck stuck onto the taper. If the hook is flipped up behind the nut then the nut can't move towards the headstock so it pushes the chuck towards the tailstock. And that releases it from the tape.
Got it!
Thanks
John

-----Original Message-----
From: SouthBendLathe@groups.io [mailto:SouthBendLathe@groups.io] On
Behalf Of m. allan noah
Sent: November-28-19 11:43 AM
To: SouthBendLathe@groups.io
Subject: Re: [SouthBendLathe] Heavy Ten conversion to L00

The hook fills the space behind the take-up nut, so that it can be
used to push the chuck off when loosening.

allan

On Thu, Nov 28, 2019 at 11:51 AM John Dammeyer
<johnd@...> wrote:

But what is the hook for?

John





From: SouthBendLathe@groups.io [mailto:SouthBendLathe@groups.io] On
Behalf Of wlw19958
Sent: November-27-19 10:56 PM
To: SouthBendLathe@groups.io
Subject: Re: [SouthBendLathe] Heavy Ten conversion to L00



Hi Dave,

Here is the progress so far:

Thanks Again for the help!
Good Luck!
-Blue Chips-
Webb



--
"well, I stand up next to a mountain- and I chop it down with the edge
of my hand"

Join SouthBendLathe@groups.io to automatically receive all group messages.