Re: How do you dismantle the tailstock support on a 1 0k?
Remove the set screw under the support, seen on the left of your first photo. Then, use a piece of round stock and a hammer and drive the shaft out of the support.
you should make a mark in order to re assemble things together the same way.
It is simple.
When I did mine, I replaced the levelling screws (located at the front and back of the levelling foot) with allen screws.
Please note: message attached
From: "Rogan Creswick" <creswick@...>
Subject: [SouthBendLathe] How do you dismantle the tailstock support on a 10k?
Date: Sat, 09 Nov 2019 13:07:22 -0800
Drink 1 Cup Before Bed, Watch Your Body Fat Melt Like Crazy