Re: Metric


I think I covered that...

>>Accuracy required is a function of intended use and length of thread engagement.



On 04/17/2018 11:33 PM, David Beierl dbeierl@... [SOUTHBENDLATHE] wrote:

 I can cut external threads that accept a commercial nut with a calculated thread error of up to 6% for .7 to 3 mm pitch
I would think that "will accept the nut" is too loose a criterion, unless the application could be served by a single-turn nut.  That would imply that you are willing to allow deformation of up to one whole thread-pitch under load before each of the few threads in the nut make contact.


Join to automatically receive all group messages.