Re: 9A half nuts

John Losch
 

2/9/18

To all,

The “missing” holes in the piece in question would have been drilled, and were not part of the casting.  It looks like that piece slipped by the inspection department.

Jcl



On Feb 9, 2018, at 2:45 PM, Steve Naegele snaegele@... [SOUTHBENDLATHE] <SOUTHBENDLATHE@...> wrote:

 

Nope, all cleaned. Look like new except for the trace amount of paint on them. 


On Feb 9, 2018 1:35 PM, "'Jon Woellhaf' jonwoellhaf@... [SOUTHBENDLATHE]" <SOUTHBENDLATHE@...> wrote:
 

Is the hole filled with crud and camouflaged?
 
From: Steve Naegele snaegele@... [SOUTHBENDLATHE]
Sent: Friday, February 9, 2018 12:11
To: SOUTHBENDLATHE@...
Subject: Re: [SOUTHBENDLATHE] 9A half nuts
 
 

That's where I thought it should be, like my 9C. Can't figure why this one doesn't. Looks original too,  as there is paint on them.
 
On Feb 9, 2018 1:08 PM, "'Jon Woellhaf' jonwoellhaf@... [SOUTHBENDLATHE]" <SOUTHBENDLATHE@yahoogroups.com> wrote:
 

Hi, Steve.
 
My 1948 SB 9A has a hole through the end of the short leg of the L-shaped reservoir on the top half nut.
 
Jon
 
From: Steve Naegele snaegele@... [SOUTHBENDLATHE]
Sent: Friday, February 9, 2018 11:42
To: SOUTHBENDLATHE@...
Subject: [SOUTHBENDLATHE] 9A half nuts
 
 

Hello all,
I have a 1963 South Bend 9A. While cleaning up the apron assembly, I noticed that the top half nut doesn't have any oil hole in it. Is this common? It has the brass tube and trough cast in but no hole. My 9C does have a hole drilled in.
Thanks,
Steve






Join SouthBendLathe@groups.io to automatically receive all group messages.