Hey!! I'm in. I'll finish my profile later. See Ya, Bob

I tried to send a message earlier, and it never came through, and I never got Bobs, although I see he's sent one.... Oh, I may have used the tms-usa.com email address, we'll hope this one goes through

Hey Chuck, Thanks for setting this up. Nice pics on the Home page too!! It'll be nice to see all the messages together and not have to sort through all the other email to see what's going on. Thanks,

Dan, Its a rainy night in Houston (a front is approaching! in the summer!! amazing!) I decided I wanted to see if my 266mhz W98SE machine would run the ASCOM driver OK..... So, it already had the ASCO

Just saw the invitation and this is a test.

Hi Everyone, This is just a quick update on the status of Photolyze, my program for unattended image acquisition. Over the weekend I pulled out all the user-dependent settings; now they are set from a

I just got thru setting up the listserver than Andrew suggested.... Lemme know if anyone has a problem joining..... Everyone on this mailing list should receive an invite. When you join, if you are no

I tried out v18 last night. Between clouds and a couple of guest observers and their problems, I managed to start the init process. After doing an offset on Sheat to get the unit tracking, I did the f

OK< ive got the old version dan gave me in shingletown and that works, (of course it works, he installed it) iva also got what he sent out early last week before i left,, floating around, in there,in

Hi Bob, well it's still G in G out! Take a look at this line, from your first 2 inits: difHA=34:12:25 difaz=35:16:19 difdec=17:10:07 difalt=16:51:13 difscp2ra=-01:03:54 difscp2dec=00:18:54 Ok, the dif

Dan, I am still unable to get visual basic to find the reference to the SiTech driver. I uninstalled the driver, and reinstalled version 13 using the installer. The SiTech driver was not listed in VB

Hi Bob, I haven't heard back from you that you tested your servo motors to see if they were indeed missing steps. You mentioned you had in the past. You're using the Flat Cable, that's good. You must

Dan, The Ascom driver worked fine for GOTOs and tracking with the wired connection last night. However, the Ascom virtual handpad did not act as I had expected. I like that the buttons function when p

Dan, Is there any way you can send me a copy of your controller config?? I would like to compare it to what I have set up on mine and see if I have a switch or something set wrong. I know the tics num

What the Hell is this? Last night, I was taking a series of 16 shots of the andromeda galaxy, it is 1/4 of the galaxy, since I am working on a Mozaic. During one of the 5 minute exposures, a star appe

I'm having trouble blending, I think 'cuz some of the photo's the sky wasn't as dark, it was lower on the horizon, and some smoke we had, Not sure how to deal with this, the most obvious is the light

Dan, I did a bit more testing last night with the motor encoder ticks, since my tries at inits the night before were bad. I didn't have time for extensive testing. If you remember, when the flat wire

Dan, Made it back from travel late last night and have been trying to catch up on e-mails..... I suspect you are out star partying this weekend, so will catch this when you get back..... I have not be

Hi Dan and all, Here is what I have tried so far: Checked for dropped tics by doing an offset init on Sheat then a slew to Altair and then back to Sheat. Scope stopped exactly back on the spot it star