Re: 1:8 H Couplers

Nathan Rich


Thanks for your comments

Knuckle pin vs stubs is definitely on the list "to improve". I have seen the couplers with the sprung knuckle as you describe, but mostly the ones I have seen are not sprung like that. Out west, we use a bottom-operating coupler, there is a tab that sticks out the bottom that you press up to uncouple. 

This will mainly be for show, as most track is too rough to allow tightlock couplers without some way of making the draft gear float. Something to keep the mind occupied though.

Nathan Rich

On Wed, Jul 29, 2020, 01:23 Tim L <tim@...> wrote:
Now that's just awesome!

It's been a very long time since I was involved with miniature rail (7
1/4" gauge but most stuff was 1:6 or 1:4.8" scale) and I don't know a
lot about the inner workings of the couplers we used but a couple of
things you could consider.

The knuckle couplers we used had what amounts to a bolt with a loop
welded to the top which functioned as the lock and lift pin (top
operated obviously). They also had a coil spring in them somehow that
threw the knuckle open a bit when you lifted the lock enough to clear
the knuckle "tang" (for want of a better word).

I'd look at the possibility of modifying the coupler drawing so that
knuckle pivot hole goes all the way through so you can use a bolt like
on the commercial couplers; it may be stronger than the short stubs on
the Sergent design.

I'd definitely look at getting them cast in metal. You should easily be
able to use the prints as the pattern for doing that, though you will
have to take into account shrinkage etc.

- Tim

On 29/07/2020 17:57, Nathan Rich wrote:
> Thought you guys might enjoy this, I upscaled the H coupler to 1:8
> scale, for 7 1/2" gauge. I wanted to test the theory, because I wanted
> to use a correct H coupler on the front of a PA locomotive a friend is 
> building.
> I upscaled the files Mr. Sergent graciously provided us by 1087.5%, and
> printed then in PLA with 20% infill. I do not expect these to be
> actually used, I wanted to make sure they would mate with commercially
> available couplers (Shown here a Live Steam Products standard E
> coupler). This just proves how accurate the couplers Mr. Sergent made
> are. I'm certainly impressed.
> For the ball, I used a 1/2" steel bearing, and the holes you can see are
> for using a Sergent pick to uncouple just like the HO version. With a
> little tweaking with a drill here and there, these things work great.
> They couple reliably every time!
> For the one to go on the actual locomotive, I'll need to 3D print it at
> 100% infill or figure out a way to cast it in aluminum or brass, and
> possibly use a different mechanism for the knuckle. It needs to be able
> to be used in an unusual circumstance, but normally it should be on the
> front looking cool.
> Cheers,
> Nathan Rich

Join to automatically receive all group messages.