toggle quoted messageShow quoted text
is this method easier than using the assembly jig? my eyes are starting to slow down, and last time I tried to assemble some, I got a little frustrated and quit like usual.
+1 on the thumb/finger over trick. I *seems* like it would *never* work but once you get the hang of it, after two or three couplers, it's amazing how well it actually works!
And that said there are still conversions where you can't get your thumb in, and then I usually give a tweezers/knife combo approach a go but if they aren't cooperating I just skip the spring :-)
On Sat, Jan 5, 2019 at 1:36 AM Tim L <tim@...> wrote:
I use the method given in the first Installation Tip
(InterMountain/Tichy Single Sheathed Box Car) on the Sergents website.
Amazing how well this method works. It's a bit more difficult when a
molded on coupler box doesn't have a flat top, like the Proto2000 Type
21 Tank Car (Installation Tip 8) but even then "finger-over" method can
work. I can't link directly to the tip, Franks site sill uses Frames
(for shame Frank) but just go to Instructions Etc on the Sergent website
and scroll down the the Installation Tips link.
On 04/01/2019 11:00, Nick Brown wrote:
> I have been an HOn3 modeler for more than 40 years. I've always used
> Kay Dee couplers. I was inspired to try Sergents by articles in the
> HOn3 annuals but only got the proverbial 'round to it' a few days ago.
> I'm wondering how anyone keeps those little springs from flying away.
> I'm trying a method that doesn't use springs. Hope it works.
Loren (LJ) Casey