Re: Membership

Nick Gully
 

For centering springs, I  skewer them on one side of a pair of needle nose tweezers, gently holding them in place with the other tong. I then point the tip into the void where the spring
belongs. With a small flat-bladed screwdriver, I keep the spring in the hole while withdrawing the tweezer blade and pressing it down so that pressure keeps it between the coupler and the pivot point. After that I slowly remove the screwdriver, and place the cover on the coupler box.

 

Best Regards,
 Nick Gully

Join SergentEngineering@groups.io to automatically receive all group messages.