Re: Coupler stock

Dale Buxton

Oh Investment casting certainly can and does use injection molded waxes! Look at these examples. The youtube vid is pretty self explanatory. 1&_vsrefdom=ppcbing&utm_source=bing&utm_medium=cpc&utm_term=iso%20%2Bcastings&utm_campaign=Investment%20Casting&utm_content=Iso%20Investment%20Casting

Dale Buxton

On Mon, Dec 10, 2018 at 6:19 PM Edward Sutorik via Groups.Io <> wrote:
Investment casting doesn't use injection molding equipment.

Reading this article:

there is a comment:  "In recent years the production of patterns using 3D printing has become which case one goes directly to step 5."  From step 1.  So, Steps 2, 3, and 4 can be skipped.  What the 3D element does is make it quite a bit easier to produce the wax patterns.  However, Cal Scale was making wonderful investment castings YEARS ago without 3D printing.  And Kemtron before them.

I believe the earlier investment cast Sergent parts were done using steps 2-3-4.  And I believe that Frank is either getting very tired of dealing with steps 2-3-4, and/or he's yearning to cut the costs of using steps 2-3-4.

Since 3D printing is mentioned in the article, it has obviously been in substantial usage.  So it's not like Frank is going where no one has gone before.  But there might very well be start-up expenses.  And start-up mistakes.  But I doubt that it's anywhere near impossible.  Maybe just too expensive.  Or irritating.


Edward Sutorik

Join to automatically receive all group messages.