Topics

Connectors


José Luiz Ures
 

Good evening
Kevin,
Which rear conector should I use TS-2000?
ACC or Comm?
Thanks

Enviado do meu iPhone


Perry Ogletree
 

ACC2 connector... BUT your interface must support hardware PTT as there is
no CAT PTT command that uses the rear connector. The Signalink USB (without
modification) does not have hardware PTT so avoid that interface for use
with a TS-2000.

Perry AFA4NQ

-----Original Message-----
From: RigPi@groups.io <RigPi@groups.io> On Behalf Of José Luiz Ures
Sent: Wednesday, August 5, 2020 6:06 PM
To: RigPi@groups.io
Subject: [RigPi] Connectors

Good evening
Kevin,
Which rear conector should I use TS-2000?
ACC or Comm?
Thanks

Enviado do meu iPhone


Perry Ogletree
 

Duh! Thought I was in another group... the RigPi is your interface...

Perry K4PWO

-----Original Message-----
From: RigPi@groups.io <RigPi@groups.io> On Behalf Of Perry Ogletree
Sent: Wednesday, August 5, 2020 7:13 PM
To: RigPi@groups.io
Subject: Re: [RigPi] Connectors

ACC2 connector... BUT your interface must support hardware PTT as there is
no CAT PTT command that uses the rear connector. The Signalink USB (without
modification) does not have hardware PTT so avoid that interface for use
with a TS-2000.

Perry AFA4NQ

-----Original Message-----
From: RigPi@groups.io <RigPi@groups.io> On Behalf Of José Luiz Ures
Sent: Wednesday, August 5, 2020 6:06 PM
To: RigPi@groups.io
Subject: [RigPi] Connectors

Good evening
Kevin,
Which rear conector should I use TS-2000?
ACC or Comm?
Thanks

Enviado do meu iPhone


K7UL@...
 

Perry,
The Signalink USB works very well with the TS-2000 without modification.  I use it with the ACC2 connector just fine........RTM


Perry Ogletree
 

Yep… it works fine with any waveform protocol that doesn’t have tight timing constraints. If it is a fast turn-around ACK/NAK type protocol the Signalink’s VOX TX/RX delay can cause problems. Luckily 99% of Ham waveforms aren’t that critical. That’s why I clarified that my remarks were made under my incorrect assumption that I was in a different group. Teaches me to check the subject header when I reply! HI!

The TS-2000 “gotcha” only applies if you need fast PTT.

 

Perry K4PWO

 

From: RigPi@groups.io <RigPi@groups.io> On Behalf Of K7UL@...
Sent: Friday, August 7, 2020 8:38 AM
To: RigPi@groups.io
Subject: Re: [RigPi] Connectors

 

Perry,
The Signalink USB works very well with the TS-2000 without modification.  I use it with the ACC2 connector just fine........RTM