I'm sad to see it go but, RigPi is definitely a step in the right direction. Adios Commcat. You've been good to me for many years. Jim

Hi Thanks for the reply. I have followed the instructions but it won't toggle on/off with the PTT button and neither using the T/R. Also I downloaded the Radio Won't connect rtf document and ran the

It’s physically connected via USB and then made available to the network by running the RSP TCP server. It’s available from the SDRPlay website. See the link below for documentation.

Hi Jim, Many thanks for the pictures, Jim! I have more or less the same setup now. Bank1 is VHF and Bank2 is UHF. So I can work on both bands. So now, I keep looking for a solution to scan

Hi Steve, maybe it is possible to disable the addons using the CMake options https://github.com/mumble-voip/mumble/blob/master/docs/dev/build-instructions/cmake_options.md Also take a look here

Hi Ron, Interesting. How do you connect SDR-Play to Raspberry Pi 4? Thanks in advance, Regards from Loic, SM5VFE

I've been working for a while to find the combination of equipment and software that would produce the remote experience I was imagining without putting out the big dollars on a Flex. I'm getting

This is really useful. Thank you! I am interested in commenting out and recompiling their 3rd party noise cancellation/AGC routine calls that cancel out low level CW signals, scoring/treating them

Thank you! -73’s Mark Schroeder, W7KHZ-🇺🇸

Use sudo dpkg-reconfigure mumble-server and select autostart

Hi all, please find at the following link the step by step procedure to compile and install last version of Mumble on the RPi https://www.pianetaradio.it/blog/mumble-su-raspberry-pi/ On the top right

After 20 years developing and supporting CommCat and 10 years for CommCat Mobile, I've decided to pull the plug on both. If you have installed CommCat Mobile you can continue to use it with RigPi,

THESE WORK ON MY IC-7610. HOPE THEY WORK ON OTHER ICOMS TOO. For adjusting the brightness levels of the rigs waterfall without lowering/raising the signal: REFERENCE LEVEL -0 db *1w

Thank you -73’s Mark Schroeder, W7KHZ-🇺🇸

For mumble-server autostart, take a look at htis link: https://sbcguides.com/install-mumble-server-on-raspberry-pi/ --Howard

Howard/all, can anyone advise the best approach or reference a website on how to get the Murmur server to autostart on the Pi? I am playing with the code a little bit and want to understand this

Johnny - Looking forward to your report! Dan N1DH

Hi Steve Thanks for the info, I have a friend who is now looking at building the interface needed. Hopefully I will be back on the air using Rigpi 2. Thanks to everyone especially Steve who has

Hi all, I'm able to install Mumble version 1.4.0 (the latest availables in the github repository) on my RPi. Let me check in the weekend if it's working well and I will share the procedure. 73 Johnny

Hi Dave, unfortunately, that cable is designed so that the RJ45 (square connector) end goes into their Tigertronics Signal Link output, with the round DIN connector going to the rig’s data/packet