I have two Icom radios. I would like to connect both to the same rigpi if possible. The 7300 has a Timewave Navigator modem/sound card/keyed for its communications. The 7100 has a DigiMaster Pro 3

Wouldn't the audio board work? Why a signalink?

Hello all, I wanted to pick your brains a little, I hope you don't mind. I have been in here reading about the RigPi, which as an older IT guy is insanely interesting to me. However I want to jump

Hi all. I want to buy a small Tablet for Android to use with RigPi. What do you use ? Thanks in advance Regards from Loic, SM5VFE

Hi Howard I changed Plumble from PTT to continuous and all works. Thankyou for your help and what a fantastic device. Keep up the great work. thanks David ZL2BA

The dropouts are on receive. I'm transmitting from the home shack with a different rig. I'm receiving with the RigPi and IC-7300, which are 8 mi away in a neighborhood that has a lower noise

Hi David, Even though there is a PTT feature on Plumble, it is not connected to RigPi PTT. That means you always have to use a browser to control PTT. The Transmission option in Plumble should be

Hi Bob, Disconnect Radio is not required when you close a browser. The radio remains connected to any remaining browsers, if present. Are the audio dropouts on receive or transmit? When you are

Hi Howard, My radio is the Icom IC-7300, connected via USB cable. This problem hasn't occurred the last couple days. I set up the rig and RigPi according to "RigPi Installation for Icom IC-7100 &

Hi Howard, thanks for getting back to me. Yes I can use the PTT on the web page and it works ok no audio out to radio but can receive as Plumble is also running. If I use Plumble alone, the PTT does

Howard, You are the man! Many regards! s -- MisterSteve/WQUR497

Hi MisterSteve, Go to Advanced Radio settings and put a check in “Disable Split Polling” and you will be all set. Restart the radio connection. 73, Howard W6HN

I recently was able to get everything connected. Today I was testing the rig control features of RSS and found after connecting to the ic 7100, the screen started flickering back and forth showing the

Hi David, PTT comes from the remote browser, not from Plumble or Mumble. You can set up the Hamlib Dummy radio in RigPi, then connect from your remote device. Assuming you have thre PTT settings

Les is correct, take a look at RigPi Help in the Getting Started section. It is also available in the RigPi Help menu. In summary, remote connections are through any browser, no special or

Hi Bob, The problem you describe can be caused by not properly disconnecting the radio when you exit. Please tell us which radio you are using. —Howard

Hi Bob, You will need to include TightVNC in the code that runs when you reboot. But I’m wondering why you are using TightVNC when RealVNC is installed and running on RigPi. The RealVNC server is

This site can get you started. https://rigpi.net Les WD5BYQ

I am in the same boat . I looked on gethub with no luck. I wrote to MFJ. They said they were going to send me a new SD card K5PDC

Larry, What cable are you using for CI-V CAT control? The cables you have do not handle the communications with the radio, as the USB to CI-V cable will do that. -- 73 - Mark - K8MHW 'A RigPi