After following the directions for setting up Mumble with the IC-7300 RX audio is working on my iPhone and on an iPad. (Note both running iOS 13.1 beta). I will test TX audio later this

I would highly suggest that one of the first steps be update the RigPi software! -- 73 KE9A

Hey, Bo. Yes, pick the IC-7300 as the radio on the left and change the name to IC-7610 on the right.

Hi Jeff, I don't blame you for being discouraged, but I have 100% confidence we can get the 857 going. I'm not clear on why disconnecting the mic would be related to the report of an unknown

Hi Bo, The CI-V address should be \0x98, using a backslash. The Power macros must start with *1w<space> for Icom radios. There is a possibility the 7610 has a slightly different command to set power

Hi Howard - I tried the other cable with the same results. I also tried to unplug the hand mic from the radio , but RigPi reported an unknown error and wouldn't connect. Its looking like I need to

All, The nice postman delivered my order today so I have the RigPi in house! I hooked it up to my 27in 4K display and a Microsoft Sculpt keyboard and mouse. I am using Ethernet for networking. My

I’m sure Bo will be saying thanks soon but let me toss mine in there too. Thanks, Howard. That works.

Bo, to fix the Power On/Power Off problem in Hamlib for the 7610, select the IC-7300 instead of the IC-7610. In Advanced Radio settings, change the Radio Name to IC-7610. Change the CI-V from

Hi Mike, RigPi has keystrokes that can be used to control PTT and tune frequency. Up arrow, down arrow: tune selected digit up or down. Left arrow, right arrow: select digit to tune. +/-: tune

Hello Don, I had a similar PTT problem with my TS-2000. I'm not sure what fixed it since all I did was completely remove and do a new install of Mumble. Follow all of the setup instructions as

Thank you. I will check above during weekend. I was out remote to try Rigpi and I noticed that I don´t have any modulation at all from my TS 590s. I have set all meny parameters in the PDF for

If I reboot with VLC Viewer then I cannot connect to anything. But If I reboot inside Rigpi then Mumble starts to give audio again. Interesting but I´m glad that I found this solution. 73 de

Yesterday was working very good. Now I´m connected but no adio at remote computer. I have noticed this Before. Also I cannot connect via Wifi. Only via tc/ip Cable Anyone know? Thanks in advance,

Ah, that explains why mine worked great. I haven't finished mumble setup so it was off. FT8 worked good.

This is a great topic. We should add hashtags to these to make finding them even faster. #IC-7300?? I will be testing this tomorrow when my RigPi arrives. -- 73 KE9A

I have one for my FT818ND I want to use which I think is the one you are using. My MFJ-1234 will be here tomorrow. Time for the ohm meter! -- 73 KE9A

Hi Bob, I can't speak for all of them, but I can say that the MiniDIN6 version is the same, and the jumper block is too. It is hard to say for certain about the rest as neither TigerTronics nor MFJ

I have a couple of Signallink cables for my radios and I was wondering if they are the same for the MFJ-1234? -- 73 KE9A

The question gets to be if there is a keystroke that will increase and decrease the frequency (I.e.: Ctl-Up, Ctl-Down). I have a Griffin Power Mate that I used with RemoteHams and basically you have