OK, I loaded it up on my Mac. Make sure you have an unformatted SD Card (delete all partitions (and MBR) if you have formatted it and the Etcher tool doesn't recognize it. If you have the .img or .tar

Go to: http://hampi.radiowaves.ca -- there are readme and install files as well as the tar file.

Either the .tar or .img file as source SD card as destination.

You don't need to format the SD, just let Etcher copy it.

You don't need to partition when copying a .img file, it clones the image onto the SD card bit for bit.

http://hampi.radiowaves.ca/

There is no HamPi v2.0. Did you install the W3DJS beta instead?

Mark HamPi is Raspberry Pi OS image with about 80 ham related applications. Each of those applications has its own documentation. You may have to do some research on them. Go to raspi.radiowaves.ca an

See https://superuser.com/a/581036 Ultimately it is the builder's choice.

I might also mention the dd and xz also should work on WSL (Linux running under Windows 10). I have the Ubuntu version installed and the commands are there. I tested xz, but have not tested dd in this

#w3djs #dd #etcher #xz #hampi

HamPi 1.0 is the current image, the W3DJS Raspberry Pi Ham Radio Image V2.0 was a beta which was replaced by HamPi 1.0 If the information you are using references "W3DJS Raspberry Pi Ham Radio Image V

#etcher #xz #hampi #w3djs #dd

Just use dd on Linux to copy the .img file to the SD card.

Trying for maximum compression.

Choose your own tools and move forward. If you don't like the features of one, pick another, or let the developer know.

The firmware to support USB boot is now in STABLE, so it should be safer to change from 'critical' to 'stable' instead of 'beta' so that you aren't always bleeding edge.

USB connected SSD is faster.

Are you using the file here http://hampi.radiowaves.ca/

I am observing an issue on RPi 4 and have passed to the engineers for validation.

I had a few minutes and loaded up the bittorrent version of the image, and burned it to a 32 GB SD card using the Balena Etcher program. I first placed it in a Raspberry Pi 3B+ and booted it up. Did t

This is the second report I have seen. I will try to get time to investigate this weekend. Please include the generation (or order number) of your DRAWS™ board.