Again, topic was hijacked.

Hijacked topic.

A typical 120vac to 5vdc power supply accepts 100 to 240 vac. Do your AC mains fluctuate out side of those limits?

Grover: ? The distribution is in the micro SD card, not in the RPi. If your RPi does not boot from a good bootable SD card, it may be broken. Are you seeing anything on a monitor when power is applied

All: Is the 'size of' the image still 16 GB ? If yes, please run df -h on a fresh image and let me know the amount of memory under 'Used' in the '/' filesystem. IIRC, the 'size of' a compressed image

Dear VE5JRP: I installed WSJT-X from repositories using apt-get install wsjtx -y , early last November. Beyond that, I do not recall ever loading any drivers. :-| I simply followed my nose. Choose the

I have the same issue. I leave a monitor connected and powered.

When far away, yes. Local, no. Intweb?

Jumping in here: To clarify, please 'copy-n-paste' your console command(s) into this thread. e.g. gelmce@gelmce-net:~$ blah-blah blah-blah: command not found gelmce@gelmce-net:~$ pwd /home/gelmce gelm

Ethernet or Shut down the RPi. Remove the SD card. Carry the SD card to another computer. Mount the SD card. grep passphrase /.../etc/hostapd/hostapd.conf ...

I do not use flrig when using WSJTX. WSJTX will control the IC-7300 without FLrig. I am not familiar with JS8. Chuck

I think that error means 'installWebMail' was not found. Referencing in line 40 of your install script. Does 'installWebMail' exist on your file system? if yes, where. Maybe share line 40 of your inst

Found a way! After installing pat (pat_0.8.0_linux_armhf.deb (Raspberry Pi)) there is a service definition for pat, here: /lib/systemd/system/pat@.service I edited it from: [Service] User=%i ExecStart

Thanks to many folks here for assistance. It turned out that someone had registered my callsign for me about a year ago but did not register an email address. I found a Winlink adminstrator and they g

My neighbor Winlink/pat guru has discovered how to start pat with P2P telnet enabled/default. How do I modify my: sudo systemctl start pat@pi sudo systemctl enable pat@pi as in KM4ACK's video to start

Salt to taste. I usually do NOOBS as it allows me to put '/' on a HD or SSHD. Then the SD card is read only (/boot) and should last forever. ;-)

sudo raspi-config and set up localization options and WiFi.

The SD card gets 'initialized' when 1st booted. Actually, it can get re-partitioned.

You are excused. Please detail how you 'flashed' your SD card so that we have a clue that you actually put the 'image' on the card and not just the file. I do not think that there is a 'initialize' re

At 6:40 into the video, I get a telnet 'failure' instead of 'success'. Likely because I do not have a 'winlink password'. For those that create these helpful YouTube® videos; it appears that YouTube®