Does not run on a Pi https://www.codeweavers.com/support/forums/general/?t=26;mhl=147220;msg=145749 Dave

Ducking around, ran into this. 73 https://www.codeweavers.com/compatibility/crossover/powersdr

Besides PowerSDR, you would also need Virtual Audio Ports, Virtual Serial Ports, DDUtils, and possibly other software to make it work with any of the mode software like FLDIGI or WJTX. Mark KD0QYN

I also have a Flex-1500. The only software that works is PowerSDR and that is only available on Windows. I have not heard of anyone trying to port it to Linux. Mark KD0QYN

I have added the Fldigi group to your issue. According to a Flex group it's a challenge. 73 Mike-VA3MW FlexRadio Employee, Community Manager admin January 14 @KK0U Hi Jim Thanks to the TCP/IP ports

Wine on Linux is probably required for basic functions. 73

If you learn of any Linux software that will interface well with the Flex 1500, please post it here. I am also interested in using a Pi to control a Flex 1500. Thanks & 73, Ed N2BHD

A Pi4 or Pi400 should work. Main question should be whether you like the feel of whatever Linux software is available for that radio. Nigel A. Gunn, ///shoulders.outwards.resolutions tel

My WIn 8 machine I use for my Flex 1500 is about dead. I'm interested in transitioning to Rasberry Pi. Anyone using Raspberry Pi with a Flex 1500? 73 Bob K4RCG

First, thank you all for your opinions, suggestions, and advice. It is truly appreciated. Now for those who have followed this journey here is how it unfolded for me. It appeared that these were my

No, but I will give that a try and see what happens. Thanks. Stephen Stocker K7SWF On 3/18/21 2:18 PM, Bill WA4OPQ wrote:

Have you tried a different value for the resistor? Perhaps a 1K?

And his text clearly stated the issue was the PiTNC-9k6 wasn't consistently triggering PTT On Mar 18, 2021, at 09:13, "N5XMT via groups.io" <gmail.com@groups.io

Yes, the PiTNC-9k6. On Mar 18, 2021, at 08:13, "Nigel A. Gunn G8IFF/W8IFF" <nigel@...> wrote:

His subject line said 9K6, his text said little.

Older thread, but I am now using the Pi-zero with PSK-31. The trick is using a more simplified program. LinPSK works like a charm and offers several modes including PSK31 and RTTY. The latest version

The Pi9K6 runs 1200 just fine. OP never said he was trying to run 9600. His issue is it isn’t reliably keying his HT.

9600 baud requires discriminator audio as it is frequency shift keying and not audio frequency shift keying like 1200 baud packet. Unless you hack in to the HT to tap discriminator audio for the 9600

9K6 is unlikely to work with mic/ls connections on your radio. Radio's audio bandwidth isn't good enough. Nigel A. Gunn, ///shoulders.outwards.resolutions tel +1-937-971-0366 Amateur

I just got my TNC and trying to hook up my Yaesu FT-50 handheld. This is the diagram I have followed, Mic to Pin1 of DB9, Pin3 for PTT and Pin5 for Spkr, GND to Pin6. When I try to poll another site,