I've been reading the setup from tncpi pdf from off the tnc-x website. I've downloaded the zipped files, there are now in the folder pitnc. Both files permission are for Owner I keep getting

Ed, ok good to go, I just got back to this to work on the pinout for them and found your post, it is now on order. Thanks AL M KF5SMh

Al, Get the 6 Pin Min Din 1200 Baud to DB9 Kantronic Type cable from HamMadeParts. Ed, KD9FRQ

Hopefully this isn't your issue, but I recently found one of my Pi 3Bs would no longer display hdmi output even though it has for months.   A different Pi worked fine on the same monitor and cable.

Dave, the Soapy/SDRPlay drivers worked with RSP2-GQRX for you? I couldn’t get it to work; perhaps I missed something. 73 Bob K4RCG

Thanks Ed, now to figure out if it is the Kantronics or 9800 style they have listed, nothing specific stated for 7900. AL M KF5SMH

I bought my cable from Hammadeparts.com (and ebay). Works fine. I have not used it in a while as I created the setup for Emergencies then packed it nicely ready to go out the door. Ed Bloom,

Dummy me I knew that, guess I was thinking I had a TNC-Pi9K6. Thanks AL M KF5SMH

Rob, I have a 40" Vizio TV I bought 11/19. I had a similar issue with it not detecting an input signal. Discovered the TV is just too smart and is picky about inputs with the default settings, but

You need to use the 1200 port on the radio. The other is for high speed packet and won’t work with a TNC that isn’t made for it. Otherwise all is good. Sent by me

OK I am thinking of trying a TNCPi with a ft 7900r, the pigate site shows the pinout for a FT 2800/2900 using the mic port. My question is my 7900 has a rear data port why can't I use it? Her is a

Not all HDMI cables are created equal, try different cable. One of the locals here just found that out yesterday. AL M KF5SMH

Running the pi with a 20 inch vizio tv out in the shop all is good. Decided to use a 32 inch vizio tv. No signal on the 32 in. When the 20 inch is on I unplug the hdmi cable Then plug into the 32 inch

Tim, Thanks! I will eventually figure it out. Knowing this will make it easier. I’ve looked at a few basic intro to Linux YouTubes and read a lot of the info at the Raspberry Pi Foundation. All

You're welcome. There are two ways to run WSPR on the HamPi image "out of the box". One is to run the "wspr-pi" application in /usr/local/bin . The second is to run WSJT-X. The SDRPlay is

HamPi is the successor to the prior image. It has newer versions of software and is also created by an automated build. It is overall better than its predecessor. -- - Dave W3DJS

The .torrent file is used to download the HamPi image via BitTorrent. However, as you downloaded the HamPi image which is 3.8GB, you already have it. Balena Etcher on Windows will flash HamPi to a

I'm a little late to the party here because there have already been a number of replies to this thread... That said: You're welcome! If you want to add AP mode to the Raspberry Pi, there are a number

These were needed for the prior image, but not the current one. Download HamPi and there will be no need for this workaround. -- - Dave W3DJS

No, I do not wish financial compensation for this. However, I do have a PDF on the desktop called "GIVE BACK' which outlines two charities I support. I would appreciate donations to be sent there. And