Re: PI Teensy TNC G8BPQ K2MJM v4 Issues


John G8BPQ
 

If you hold the board with the Pi edge connector to the top and the USB connection to the left then the jumpers are fitted horizontally on  the right hand pair of pins.

73,
John G8BPQ

On 04/12/2020 19:01, Mike - KB0FX wrote:
Matt - Thanks for the quick response! I have verified that logging is turned off to the serial port. I am trying to run pitnc_get/setparams and it just keeps trying and trying. The V4 board JP3 & JP4 heards on have three pins. I have pins 1 & 2 jumpered on both headers. Is that correct? 

73 - Mike - KB0FX

On Fri, Dec 4, 2020 at 12:08 PM Mat Murdock <mat.murdock@...> wrote:
Make sure you have enabled serial port on the pi.

sudo raspi-config


Option 5 - Turn on SSH and Serial interface, No for login shell of serial, Yes for enabling hardware

Finish


sudo reboot



It would also be good to post what the exact command is you are trying to run.

Mat

On Fri, Dec 4, 2020 at 10:14 AM Mike - KB0FX <mweilb@...> wrote:
I have a PI Teensy TNC G8BPQ K2MJM v4 I am trying to get working with a Raspberry Pi 3B+ . This board has a Teensy 3.6. I have been able to use the firmware loader to install Pi9K Raspberry Pi Firmware Tennsy36 0416202.hex. Once attached to the RPI I am unable to communicate with the PI TNC via the serial port using pitnc_getparms. Has anyone else worked with this board?

Thanks

Mike -KB0FX

Join RaspberryPi-4-HamRadio@groups.io to automatically receive all group messages.