toggle quoted messageShow quoted text
AND, just figured out the jumpers as well... Moved from the 1st and 2nd pin to the 2nd and 3rd, and they DO connect properly to pins 0 and 1... Got way ahead of myself with troubleshooting at first and was moving the jumpers around... Back to serial 1 in TeencyPacketConfig.h and all is well.
My coastal chipworks board is that same one and goes to pins 0 and 1.
The new K2MJM V2 runs the pi serial to ports 7 and 8 thru the jumpers next to the GPIO header. Those were swapped RX/TX as well. Just used 2 jumper wires and cross jumped those headers and serial now works with hosstserial set to serial3 in TeensyConfigPacket.h
On Jun 14, 2020, at 21:24, Mat Murdock <mat.murdock@...
My version 1.3 5/21/2016 PCB from Costal Chipworks has pins 0 and 1 going to the PI headers. pin 7 and 8 are not connected to anything. Do you have a different version?