Re: PiTNC9k6 settings


N5XMT
 

My coastal chipworks board is that same one and goes to pins 0 and 1. 
The new K2MJM V2 runs the pi serial to ports 7 and 8 thru the jumpers next to the GPIO header.  Those were swapped RX/TX as well.  Just used 2 jumper wires and cross jumped those headers and serial now works with hosstserial set to serial3 in TeensyConfigPacket.h


On Jun 14, 2020, at 21:24, Mat Murdock <mat.murdock@...> wrote:
My version 1.3 5/21/2016 PCB from Costal Chipworks has pins 0 and 1 going to the PI headers.  pin 7 and 8 are not connected to anything.  Do you have a different version?

Mat

Join RaspberryPi-4-HamRadio@groups.io to automatically receive all group messages.