Re: VHF Interface for FDM-DUO


Hi Andy,
My RF Explorer does not have the sig gen facility but I do have an ADF5355 unit that I am improving the psu on to work as a sig gen. Good to hear that the DUO can be used as a spectrum analyser. 
73 ,

On 9 Oct 2019, at 19:48, Andy G4JNT <andy.g4jnt@...> wrote:

Not sure what you mean by " ... confirmed to be as per the design."   The only bit that will need adjustment is the bandpass filter.  That can be tuned "adequately" even without test equipment by just tuning for maximum smoke.   But if you have an adjustable signal source then the FDM-DUO itself can be used as a spectrum analyser, using the SW2 software in as wide a bandwidth as you can achieve.   Then vary the input frequency and look at the resulting output level.

Doesn't the Rf Explorer have a signal generator function?

On Wed, 9 Oct 2019 at 19:03, Dave via Groups.Io <> wrote:
I have been following this thread with interest. My question is how when the interface is built it is then confirmed to be as per the design. My understanding would be that a signal generator producing a signal at the right level would be fed into the receiving unit and a Spectrum analyser would then record the output at different frequencies to produce a graph . I do have an RF explorer and wondered if this would be good enough. 
Dave G4GLT 

On 8 Oct 2019, at 15:55, Andy TALBOT <andy.g4jnt@...> wrote:

It was some time ago, but I imagine I simply labelled the component values as those that came off the AADE filter design software, rounded to 1 decimal place.
I always use several capacitors in parallel for applications like that - not least as there's a higher chance of tolerances cancelling out for a more accurate average.
But at those values strays often intrude, anyway.

Occasionally on diagrams I've specified the parallel equivalents for what was actually used, depends at what stage the diagram is actually annotated with values.

On Tue, 8 Oct 2019 at 12:26, John G4SWX via Groups.Io <> wrote:
As I did the original filter design for Sam G4DDK's 144MHz Anglian transverter I wondered about your design of the 144MHz bandpass filter. So I have modelled it.
I assumed Q values of around 200 for air wound coils and 500 for bog standard SM capacitors.
I get around 2dB insertion loss and indeed an excellent response. 
But I don't see the need for 12.2pf and 15.7pF capacitors, you have used quite a few SMDs on your board to get to these values.
If you change to 12pf and 15pf values with suitable small changes in the values for the inductors(which are tweaked) you end up in almost the same place.
likewise dropping the 0.8pF value to 0.75pf has little impact on the response and allows the use of a single component.

John G4SWX

David (G4GLT)

David (G4GLT)

Join to automatically receive all group messages.