I tried this and get 3 pages of alpha-numeric garbage! -- Jon MillerFor me time stopped in 1941Digitrax Chief/Zephyr systems, JMRI UserSPROG UserNMRA Life member #2623Member SFRH&MS

Hi Marcus, The file mentioned simply states: "copy and paste the following URL to your browser. http://www.members.optusnet.com.au/mainnorth/alive.htm " KJ

Hi Jack and cgevaert Use the instructions under the heading of “To find the DC Negative of ANY decoder not shown above”, two thirds the way down my “alive” page

Hi KJ, Thank you so much for the information Jack

I also would like to install a Keep Alive in an Atlas HH660. I have looked at the http://www.members.optusnet.com.au/mainnorth/alive.htm page many times and still do not see a picture which will

Hi Jack, See the "Files" folder above. KJ

Hi Gang, I recently purchased an HO Atlas Atlas HH600 diesel locomotive equipped with a factory installed QSI decoder and I would like very much to install a Stay Alive module on it. The read back

This is a very good subject. :-) I was meaning to post something like that myself, but my interest is slightly different. My first encounter with a QSI Revolution decoder was in a Walthers N scale

Hi Kelly, Many of us are anxiously awaiting the new upgrades and sound sets that various members have suggested and requested. Any news you'd like to share with us? Personally, I'm looking

Thanks. I stumbled across that link right after I posted here, which is why I ended up deleting my original post. I do have another question though, which I asked in a new post: is there any way to

http://shedaker.wixsite.com/shedaker/applications Jay Beckham Building a large O Scale layout in Berkeley Springs, WV. Our Yahoo Group: Join: jaysoscalelayout-subscribe@... (The model

Hi, I need to pull all the .wav files that comprise a certain horn out of a .q2 file. Is there any way to do that? Thanks, Ben

Hi all: Since Josh has remained silent and is probably in debt, it is my opinion that QSI will not be compensated for the re-design, components, and any royalties that would be due from the sale of

benjaminshell@...> wrote : >The new G-Wire board was produced, it's just that for some reason Josh never advertised it. It has an updated lower cost chip--the original was expensive and finally

I had heard 2nd/3rd-hand information along similar lines—that there was a design for the new chips, there were problems, then a re-design which was still being tested but not yet put in production.

Kelly, wow, the mysteries of QSIS continue. Very interesting. Thanks for explaining. Ben

Hi Ben: No it does not use the HP device. QSI designed the replacement device for QSIS, which you found on ebay, but as far as I know, QSIS never placed them into production. I suspect there are only

Kelly, That's interesting. Does the design you guys own use the HP RXM-9000-HP3-PPO chip? Because it's obsolete... Josh says it was lot of work to redesign to work with a new radio chip. I hope this

We at QSI have no knowledge of anyone producing this item. QSI owns the design, and we could make G wire receivers if there is sufficient interest. Kelly QSI

The new G-Wire board was produced, it's just that for some reason Josh never advertised it. It has an updated lower cost chip--the original was expensive and finally discontinued--and it seems to be