I have tried to go to the site over the last 3 days. I come up with a blank screen,tried to call and message box is full. Anyone else having these problems, or know the reasons?

Thanks Elie. I found it also on page 127 of the DCC reference manual. http://media.wix.com/ugd/0f7119_33c33dacd2ff475f918159313227c7c2.pdf I was thinking bell ring period was the delay for how long

yes. cv 55.3.6 (bell ring period) and 55.3.7 (bell metalurgy) elie On Sunday, December 20, 2015 8:27 PM, "ewarhol@... [QSIndustries]" wrote: Is there a way to adjust

On 12/20/2015 5:48 PM, 'bob waldele' rwaldele@... [QSIndustries] wrote: That was a good thought but I just checked and CVs 15 & 16 are not listed. Which I assume means

 Jon following up on Jim A's comments and "appears toreadback (some) ..." suspect the decoder may be LOCKED. (CV15and CV16 are not equal). I am not familiar with brand-D processes (NCEPowerCab or

Is there a way to adjust the bell ring rate in CV Manager? I'm using a 10amp Titan, GE Dash 9 Modern Q3 sound file, and latest version of CV Manager. If the bell ring rate can't be adjusted in CV

John: Any magnet will do. It's a reed switch so if the shell is off the glass tube is the switch and as was suggested just jumper around. Sometimes the switches will fail and not

Jon, you can also place a jumper around the reset device and use it as the magnet. Lou

Just purchased a used Atlas engine. The decoder seems to work (sorta of*) but resets sometimes (test track) and does not want to take programming. I am using a SPROG, without a booster, so is

If you still need a wiring diagram I have one for the 3rdRail E-7. It shows the connections to the decoder, and the connections to the "adapter" board into which the decoder plugs. -- Rod

Hi Gerry, Thank you for answering all my questions/requests. If I don't talk to you before the big day, have a merry Christmas. Cheers, KJ

Why not contact the seller, 3rd Rail? Charlie Pitts O Scale Trolley and Railroad Modeler Norwood, MA

KJ, I will forward this request to the other QSI engineers for discussion. >>> BTW, what CV(s) does one need to program to add Function 13 - 28 to a consist? I know CV21 covers Function 1-8 and

I have a decoder that a friend removed from a Sunset GGD FT because he uses MTH stuff. It is brand new. I want to install it in one of my EMD F units. However, the wires do not seem to be NMRA

This goes to QSI, I really hope this can be done. I'm requesting something outside the box. I'm requesting a Function that can be assigned via the function mapping pane in CV Manager. I've

Hi Lou, Thanks for the suggestions. Unfortunately, the owner of the locos has taken them off the layout. I didn't have my gear set up at the club anyway, so I couldn't do anything more than a POM

KJ, Try loading one of the sound files in to the decoder. See what the programmer says about compatibility. Just a thought. Lou

Thank you all, Question: Isn't Atlas currently installing some GE units with Titan-SD ver. 9 firmware? Which locomotives? Nick, I am boycotting MTH because of the owner's greed and lack of ethics

Very well explained Gene Gleason

KJ, >>> Can these locomotive be upgraded to version 9 firmware? <<< Version 7 firmware will not run on Q3 (FX, Titan) decoders. Version 8 and version 9 firmware runs on Q3 decoders, but will not run