Date
1 - 4 of 4
#40m qcx+ #40m
|
Don Blachura
Need a liitle help. What rig do you select in logging software to use the "cat' on the qcx+?
I see the port in my Device manager, but from there I am lost. Don...w2xb (using aclog by n3jfp)
|
|
|
|
Ronald Taylor
Page 138 in the manual... Kenwood TS-480 4.28 CAT Control commands (PC remote operation) The CAT command system is intended to allow the QCX+ to be used with logging software (general and contest) which uses CAT control commands to query the transceiver for information entered into the log, typically operating frequency, mode etc. A subset of the Kenwood TS-480 command set is implemented, with a few minor modifications. QCX+ assembly Rev 1.03 138
Need a liitle help. What rig do you select in logging software to use the "cat' on the qcx+?
|
|
|
|
Don Blachura
Tu Ron. At 83 my mind is getting a little rusty.
Tu agn. Don...w2xb
|
|
|
|
Bruce K1FFX
If your logging software is N1MM+, you may have better results using the "KENWOOD-SLOW" setting.
- Bruce K1FFX
|
|
|