Keith that happens here once in a while when the computer is on for extended periods...things go fuzzy...just do a reboot and all ok...have no idea what causes it. Vern Sent from my BlackBerry 10 smar

Subject says it all. Hope to catch some of your flame throwers.

IT’s the postal service…it will be there when it gets there…out of your control J

How much ahead Jim

Sri missed the +10 seconds in email…not awake yet here LOL!!

Looks like I lost it Jim…not seeing it anywhere on the 20m band

I have 5 recent decodes Jim at +15 seconds… my dial at 14.095.500 1412 -15 4.5 14.097053 0 8T8XKA LK55 53 10586 1434 -24 0.6 14.097063 0 N2NXZ GL25 10 2328 1436 -24 0.5 14.097062 -1 085CDG OO23 37 898

+22 sec now…

All yours Jim...no decode since 1700z...hopefully it will sort itself on tomorrows reboot unless it is locked from the altitude. Good luck... Vern Sent from my BlackBerry 10 smartphone on the Rogers n

Jim is the timing bang on

Sent from my BlackBerry 10 smartphone on the Rogers network. From: Daniel Ekman (kng) Sent: Wednesday, September 6, 2017 12:49 PM To: QRPLabs@groups.io Reply To: QRPLabs@groups.io Subject: Re: [QRPLab

Dave what is the exact TX freq. on 20M supposed to be?

Thanks Jan

Hi all, Have had this kit for some time sitting on the shelf so I thought I had better assemble it. I do have one question. I am only interested in the " Simple Assembly ". Will it run on version 3.09

Hi all, I just completed the 5 watt amp kit and fired it up...glad to report no smoke but also no output. Turning the bias wide open did not do anything...I set the U3S at around 250mW before removing

Hi guys, Just to let you know that the reason there is no output is that I have the incorrect version firmware in my U3S. I was planning on building the simplified kit so didn't order the version 3.12

Hi all, I now have the V3.12 controller chip set up and working in my U3S. I have the 5 watt PA built with full assembly. My question is if I leave the PTT and the Cosine Shaping in a non-active state

Well after connecting the control wires and then checking everything again to make sure all was what it was supposed to be I connected the U3S to a dummy load and hit the switch. Everything powered up

I just noticed that when I press the right button on the U3S it does not key the transmit like 3.10a did…do I have something set wrong? Vernon

Thank you…