Hello Ian! Welcome to FT8. FT8 has many different outcomes, some people try it once and just think its not for them, a few of us get together once a week and hang out while trying to make as many

My QRP Labs receipt but not the PayPal receipt ended up in my spam folder, also. PayPal should also list the invoice number if you used it. Fred W0FMS

Hi Nahuel, I am not sure about this but will go ahead and throw it out as a possibility. The voltage sensor is using a divider that is too close to the impedance of the circuit being measured. Maybe

Steve, The QCX trouble shooting page is here: http://qrp-labs.com/qcx/qcxtrouble but you may just start off by trying the one finger method of pushig and wiggling ICs and components with a finger or

I've been pretty busy lately and didn't even know about this new kit. I'll be paying attention from now on, because this is something that would be useful to me for sure. -- 73, Dan - W2DLC

Buttons / rotary encoder don't work properly My QCX + 40 has worked flawlessly for many months since construction was completed. Now : 1. the rotary encoder will not change frequency when in VFO

Thank you Hans, I know you are a busy man. Thanks for all the great projects. -- KE4LJH Steve, Florida

Nice update video. Covers the QDX info and progress to date and all in one place! jim W3APC

Thanks Hans I’m looking forward to building another of your great designs for SOTA adventures Regards, Jay -- Jginaz

Thanks. That's the problem. There is no version number that i can tell. The only thing is has on the entire board, other than component names, is QRP Labs 2020. If there was a version number i could

Hello everyone, in the session 13:00 at 30m he called me DK5FN with KX3 + 15W and when he learned that I have QCX he finished the session also with QCX. I also worked with two QCX stations G4CWS Chris

On Tue, Oct 12, 2021 at 03:08 AM, Steve Rawlings wrote: I see that there is a OEB (output enable) input pin on the Si5351A. If I pull OEB 'high' on receive, will the current VFO/Signal Generator

Hans, I didn’t get an email confirmation, but the order status shows Complete for order 50106. Aug AG5AT

Hi Ian I am happy to do a zoom or similar session with you to give you a live demo and also show you how I upload my logs to eQSL and QRZ logbook, as well as JTAlert that provides additional

https://www.g4ifb.com/ has a great guide, but it may be overwhelming for beginners. You should install the program, have it on receive only for some time and try to figure out what is happening. Also

Ian The qso sequence is built into wsjt-x. There is a setting to automate. 14 seconds goes fast so automate, except when doing S&P sometimes. If you have a rig set up for digital watch some contacts.

Not much participation in this edition. I guess most people were waiting for the QDX pile up, hi. At 1300Z I had only one QSO on 17m, no QCX. I was using my QCX Mini 17m at 5W and 100ft endfed

See https://groups.io/g/QRPLabs/album?id=252309 73, Sheldon, VE1GPY

Ian, A study of the very fine manual is worthwhile. https://physics.princeton.edu/pulsar/K1JT/wsjtx-doc/wsjtx-main-2.5.0.html There must be a wealth of information in the group but my impression as

There is also a specific groups.io WSJT-x group as well with lots of info main@WSJTX.groups.io | Topics Peter M0PWX M0PWX Grabber Page (qsl.net) From: Ian VA7ITM While waiting for the