How about a USB-C port and built in sink circuit, so a Power Delivery battery bank can plug into it directly? I plan to do that with a couple of my QRP rigs. I just have a smart cable adapter at this

Time and ear stimulation, in one zero-power, steampunk accessory.

Mike, This will be an experience for you. After decades of crystal filter IO/Phasing radios are like a whole level of less distortion. Less distortion, less group delay, it sounds much cleaner

> P.S.: Did you send me a private message a month or two back? No, you didn't. It was someone else. Sorry! -- "As Dunning has suggested, the very trouble with ignorance is that it can feel just

On Fri, Jun 5, 2020 at 10:09 AM, Dave, W0DF wrote: > True Blue you have combined excepts from my post with someone else’s but credited both to me. Strangely, in the groups.io forums messages, there

I used one of the other alarm outputs to control a simple ‘mute’ circuit to stop this tone when the alarm is not sounding. Instead of connecting one side of the loudspeaker to earth, connect it to

Maybe I've jumped the gun a bit. This will be my first experience with polyphase demodulation as I am so used to listening through 2.5 and 3.0 Khz 8 pole crystal filters. These have been difficult to

On Sun, Jun 7, 2020 at 07:33 PM, ajparent1/KB1GMX wrote: Andy, Forgive me I could not resist. FYI TOY is Time 0f Year,At least it gave a good chuckle, today has been very boring otherwise ;-)

Jim, or the famously annoying 1+. They never ever held a product up. Allison ------------------------------- Please reply on list so we can share. No private email, it goes to a bit bucket due address

Andy, Forgive me I could not resist. FYI TOY is Time 0f Year, and there are many time keepers like the infamous Dallas DS1287 with the internal 10 year battery, likely measured in dog

On Sat, Jun 6, 2020 at 05:51 PM, ajparent1/KB1GMX wrote: AN external TOY cock chip run on back up battery.Ahem ;-)

Like tuning other coils its part of that. Try compressing or spreading turns. Allison ------------------------------- Please reply on list so we can share. No private email, it goes to a bit bucket

On Sat, Jun 6, 2020 at 09:51 AM, ajparent1/KB1GMX wrote: some of us call the general trend here creeping featurism.Hey, I know how that works: they want more, more, more, but don't add any cost to

Never mind, I see you already have a taker. -- Julian, N4JO.

I think I"m going to have to bite... David. OK to PM ? -- Julian, N4JO.

Hi Ron Good to have your support for the theory. Thanks for the tip re pin16. Too late to try this evening - will give it a go tomorrow with fresh eyesight! Mike

I run 0.5 watts into a short 40 meter dipole in my attic and get worldwide spots consistently. Your antenna is fine. But, if you’re in CW mode, it won’t transmit WSPR. Mike WM4B

Hi Mike: We're probably about the same age (I've been licensed since 1954) and suffer the same issues when building anything any more. Still, I've learned to enjoy SMD parts and find them probably a

Hi, Mark If you have 5.2 watts showing at the 3 output FET's and 0.69 into a KNOWN GOOD 50 OHM DUMMY LOAD at the antenna jack, I would check for (1) continuity from C21 to the center

£45 ok. Cheque, paypal, bank transfer…? 73 John M0JBA