Re: Up-to-date QCX+ tips as of July 25, 2020 #qcx+ #case #manual #enclosure


N3MNT
 

I slid a piece of 0.5m PETG ( clear plastic sheet)  98mm x  130mm  under the board just as a safety measure to prevent a high solder joint or lead trim from shorting to the case.  I used female headers to make short interconnect cables to connect GPS and ISP  between the rear panel and the board.  This makes removing the board for any work easier. 

Join QRPLabs@groups.io to automatically receive all group messages.