Re: Help needed to update QCX firmware #qcx #firmware


Podolsky A
 

Shirley....you did it! You put me on the right track. After reading your post, I went back to inspect the jumpers connecting the QCX to the Arduino. Lo and behold, I discovered that one of the pins on the QCX (it happened to be the MOSI pin) had a bad solder joint. I re-soldered it, reconnected the jumpers and VOILA!!! Now AVRDUDESS correctly detected the atmel chip and then correctly programmed the firmware. Thank you. Thank you. Thank you!
73 de Arnie W8DU

Join QRPLabs@groups.io to automatically receive all group messages.