Re: New qcx build, and problems
Thanks Richard.....Some more time at the bench today, and I also
found what you noted.
So, I have my clk2!! :-)
Buzzing out my transformer showed that winding 2 is not making
continuity at the specified pads.
So, I pulled it out, and will rewind/reinstall tomorrow.
Got my fingers crossed that this is the culprit!!
On 12/9/19 5:48 PM, Richard G4TGJ wrote:
I've just checked my QCX and there is only a signal on pin 10 in alignment mode. There is no signal in receive mode. I didn't check transmit.