Re: U3S Case front panel push buttons
Alan de G1FXB
To prevent excess heat reaching the switch body, clamp a haemostat* between the switch and the tag.toggle quoted messageShow quoted text
*A pair of needle nose or pointed pliers held shut with an elastic band is a good substitute.
On 06/12/2018 17:02, Curt M. wrote:
I'm sure there's probably something else out there but it seems like the key with those switches is not put too much heat on the terminals when you solder the wires in place. They seem to act very similar to relay contacts when you put too much current across them. We used to always say that the contacts were "gulled", not sure if that is the correct spelling or even the correct term but that's what we used to say where I worked a number of years ago.