Re: QCX Alignment


Vernon Matheson
 

Thanks Kurt, but I can’t even enter the alignment menus at all by pressing and holding the left button.

 

Vernon

 

From: QRPLabs@groups.io [mailto:QRPLabs@groups.io] On Behalf Of Kurt Zimmerman
Sent: Friday, April 20, 2018 7:26 PM
To: QRPLabs@groups.io
Subject: Re: [QRPLabs] QCX Alignment

 

Vernon;

    What you are seeing is the CW decoder attempting to decode the white noise.  Continue through the alignment process.  When I did my QCX/40 I think I was on the air in about 10 min.  

 

73;

Kurt - W2MW

-------- Original Message --------
Subject: [QRPLabs] QCX Alignment
From: "Vernon Matheson" <vmath@...>
Date: Fri, April 20, 2018 3:22 pm
To: <QRPLabs@groups.io>

Hello all,

 

I finished up my QCX today and fired it up to do the alignment.

 

After adjusting R47 saw that it showed 80M as per the manual.

 

I pressed the left button and turned the encoder till 40m showed and then pressed the left button again to select  and it showed two rows…

 

A 7.020.00 on the first row and on the second it just showed a row of capital T’s     T T T T T T

 

I then pressed the left button to go to the menus and it will not go there even if I hold it for 30 seconds.

 

So I haven’t even got out of the gate yet.

 

Vernon

 

 

 

 

Join QRPLabs@groups.io to automatically receive all group messages.