Hello Scott how are ya ? Hey i made a new logbook using NU4N/qrp. But in the LOTW page I changed the call to NU4N/qrp with correct password and named the location qrp which match's the TQL

That is ok . last time what I wanted was there but I did not see it. all set up for the upcoming qso parties this weekend. Best to you and Kim Mel

Hi Mel, Thanks for your e-mail. Sorry, I don't currently support the DE party at this time. 73, Scott N3FJP http://www.n3fjp.com Serving the Amateur Radio community with contesting and general

I am unable to locate the deleware out of state qso part logging program Mel NE9A

Thanks Scott I got it working.

Agreed, I have been working on that, still, cant see how it worked so well so long before problem arose. have lots of chokes. obviously need more.

Hi Paul, Thanks for your e-mail. Those are classic symptoms of RF in the shack. You'll need to correct that before the software will function properly. Good luck! 73,

all was working fine with ts-590s suddenly had fldigi freeze on TX with ant1, had to close and reopen , worked fine on ant2 then failed again on ant1. got error msg, cant remember but about conflict

Hi Dale, Thanks for your e-mail. When you download records from LoTW, one of two things happen. Either existing records are marked appropriately (and not added a second time), or you will receive

In September of last year, I purchased the ACL Log. I immediately loaded it with most of my N1MM ADIFs and ADIFs from textfiles from a logger program I wrote in VB5 years ago. That amounted to 29k+

Fred and others: If it is any help: Many of the programs that list the grid square are based on the grid square of the Post Office, not the actual grid square of the station. I had

Ruarto, Are you logging FT8 qsos with JTAlert ? John - K9IJ -- No trees were killed in the sending of this message. However, a large number of electrons were terribly

Hi, Thanks for the good report! Enjoy! 73, Scott N3FJP http://www.n3fjp.com Serving the Amateur Radio community with contesting and general logging software since 1997. 1 Peter 3 vs 15: Always be

Hi Ruarto, Thanks for your e-mail. AC Log always defaults to the last power entered on subsequent contacts. Just be sure to enter the proper power level any time you change power and the following

Hi KU4CQ, Thanks for your e-mail. I'm sorry that you've run into trouble. It sounds like your Internet protection software is clamping down on the installer. Giving the installer the proper

New Info.My problem was an incorrect grid square info related to my station location in TQSL. My grid square is CM98iq. The incorrect data was CM98hq. I don't know how long the wrong data was there,

I normally stay at one power setting (45w) but occasionally will pump it up to 90. But each qso it logs as 95w. How can I change it so that I don’t have to go back and edit each and every

I am trying to install the FD log on a Windows 10 Dell Laptop. The installer starts then disappears. Any help would be welcome.

Thanks, Scott. Found it right after I posted the question (always happens!). Sorry to bother. --  Mark D. Johns, KØJM Minneapolis, MN

Hi Mark, Thanks for your e-mail. To sort your log file on date, click File > Sort Log on Date. How do I sort my log file by date? http://www.n3fjp.com/faq.html#q87 Enjoy! 73,