Hopefully the photo of my saved log will be visible. I have the box checked in save log every time I shut down AC log. Two questions: 1. The bottom two lines are shorter in length compared to all

Chuck, I understand that this is not a CW contest, but have you tried, in the rig interface setup, checking the box “Don’t send CW mode change if on CW (so CW filters won’t reset)”?

I Have been asking the same question for a while on the IC7100 no answers :(

Using the CQ WPX Contest software with my Icom 7300, I noted that every time I tune to a frequency using the DX Spotting panel, the rig always switches to "FIL2". If I manually toggle it to FIL1, then

Jim Why not uninstall and reinstall the software? 73 Larry K1ZW

Hi Jim, Thanks for your follow up. It is extremely unusual that you are not able to see the rig interface set up form at all. The only thing that I can think to suggest is to make sure that your

In the Rig setup try these settings Control-R Icom 7100 Rig Name = Icom Read Frequency Command = FE FE 88 E0 03 FD Read Mode Command = FE FE 88 E0

That worked! Thank you! 73, Megin, K5IJ

Ed Jones, Thank you for the specifics. I would love to put in that information but it isn't allowing me to even select the radio! As I said to Scott it is as though a module didn't load! Jim

Scott, I am sorry to draw this out. I can get to the rig control with another program. What is happening with your program is that when I go to Settings and then to Rig Interface, NO CHOICES are

Hi Megan, Clicking on the “Worked” column will copy the list to your clipboard. Then just past it to whatever. 73 -- Larry -- W1DYJ

I found how to view the list of countries I have confirmed on 80 meters, but is there a way to export just that list? 73, Megin, K5IJ

Thank you Scott. I comparing the times in ACLog with the times on the screen of my Icom 7610, which were incorrect. My Bad. Sorry for BW. 73, Les. VA7RN

Scott Thanks that worked. Mel NE9A

Hi Les, Thanks for your e-mail. Please see this FAQ here: How do I set the UTC clock offset with the new versions of your software? http://www.n3fjp.com/faq.html#q51 Enjoy! 73,

The time showing on my Amateur Contact Log is incorrect. The local time is off by 1 hour ahead and the UTC time is off by 8 hours ahead and I do not see any way to correct this. How can I correct

All you should have to do is go to settings then DX Spots, Configure and then uncheck and recheck "Enable DX spots" ..You should not have to shut down the entire program. -- George-- KM4ODS

Hi Mel, Thanks for your e-mail. Click Settings > Setup and choose SSB. Also, make sure your rig interface is correct. Both are addressed in this link

Scott Install went well except for one thing. Mode shows as digital and I cant seem to change it to ssb Mel NE9A

Jim. Here are settings for the 7100 Icom 7100 Rig Name = Icom Read Frequency Command = FE FE 88 E0 03 FD Read Mode Command = FE FE 88 E0 04 FD Convert To Hex = True Baud Rate = 19200 Parity =