Re: Cannot get N3FJP software to work with new IC7300

Scott Davis

Hi John,

Thanks for your e-mail.  I'm sorry that you have run into trouble.  I'm by no means an OS guy and your question is way outside my area of expertise, but if you are losing com port access from your OS, my guess would be something is awry with the device driver.  Hopefully someone more knowledgeable in this area will have additional insights for you.

Be well and enjoy!

73, Scott

Serving the Amateur Radio community with contesting and general logging software since 1997.

1 Peter 3 vs 15: Always be prepared to give an answer to everyone who asks you to give the reason for the hope that you have. But do this with gentleness and respect...

-----Original Message-----
From: John <radio@...>
Sent: Fri, Feb 12, 2021 7:45 pm
Subject: [N3FJPSoftwareUsers] Cannot get N3FJP software to work with new IC7300

I can't seem to get N3FJP programs to work with FLdigi and AClog or CQWPX with my ICOM 7300.  Ether FLdigi or the N3FJP programs work alone.  I also can't get WSJT-X to work with the logging programs.

My setup with a TS-440s and Hermes SDR never had a problem and worked well with all the many N3FjP programs I used over the years.

Starting a logging program first and setting up the API to Enable Server on port 1100 and then starting FLrig and FLdigi causes port 6 on my PC to disappear.  Port 6 is the USB port for the IC7300.  The FLrig and FLdigi setups are according to what is recommended on the IC7300 settings on Source Forge.

Any idea what I'm doing wrong?  I have spent a lot of time and tried many things, but the result is always that it doesn't work.  Is there something about Windows 10 I should know?  I recently upgraded from Windows 7 so I could run my tax program.

John,  W0GN

Join to automatically receive all group messages.