Re: Problem with ACL and SatPC32 interface with Kenwood TS2000

Scott Davis

Hi Steve,

With the Kenwood option, my software first looks for FA in the returned string.  If it doesn't find FA, it then looks for FB.

With the Kenwood2 option, your rig should return the active VFO regardless.  In that case, the software looks for IF.  

I hope that this helps!

73, Scott

Serving the Amateur Radio community with contesting and general logging software since 1997.

1 Peter 3 vs 15: Always be prepared to give an answer to everyone who asks you to give the reason for the hope that you have. But do this with gentleness and respect...

-----Original Message-----
From: Stephen Malyszka <s.malyszka.jr@...>
Sent: Mon, Jan 18, 2021 4:33 pm
Subject: Re: [N3FJPSoftwareUsers] Problem with ACL and SatPC32 interface with Kenwood TS2000

Hi Scott,
Thanks for looking.
I think I know what's happening. Satpc32 Commands the TS2000 Receiver A and B (SSB U/L) about every few sec for doppler correction and frequency read. ACL polls the TS2000 every 2 sec by setting. This occurs over a single COM port using a virtual COM port splitter.

Please refer to the screenshots attached. Does the ACL code ignore the tag FA or FB  of received data to determine which Receiver frequency to enter into the log?  Or does it ignore the Tag assuming it is the response from the Receiver that was commanded to read? When Satpc32 is not running, ACL works fine. Please confirm.

Many thanks,
Steve AG2J

Join to automatically receive all group messages.