Re: Spotting stops working
|
Pat Whelton
Hey Mel. Not sure if this will match your situation or not but after I acquired a new PC I had the same issue you are experiencing. What I did to fix (repair) the issue was go into the Power & Sleep settings and change the Sleep setting to “NEVER”. I don’t remember what the factory default is but every time the new PC exceeded that default it would lose it’s DX Spots because it was no longer connected to the internet.
Again, this might not be what you are experiencing but who knows. Give it a shot.
Regards,
Pat – KZ5J
From: N3FJPSoftwareUsers@groups.io <N3FJPSoftwareUsers@groups.io> On Behalf Of Mel - N7GCO - Cheney, WA
Sent: Friday, July 10, 2020 1:09 AM To: N3FJPSoftwareUsers@groups.io Subject: [N3FJPSoftwareUsers] Spotting stops working
When using AC Log, I will start the DX Spotting and it will work fine. Then it will stop receiving new spots. If I switch to another Telnet spotting program, again it will work fine for awhile then stop again. If I now switch back to the original it will start again only to stop latter. _._,_._,_
|
|
|