Re: Rig Control Issue with ICOM 7300

Scott Davis

Hi Scott,

Thanks for your e-mail.  I'm sorry that you have run into trouble.  I've had lots of good reports on the 7300, so I am sure the software is fine.  You will find the detailed settings other 7300 users have sent along here (there is even a video specific to the 7300):

Note that no other users reported the baud rate you are trying.


73, Scott

Serving the Amateur Radio community with contesting and general logging software since 1997.

1 Peter 3 vs 15: Always be prepared to give an answer to everyone who asks you to give the reason for the hope that you have. But do this with gentleness and respect...

-----Original Message-----
From: Scott <scolit@...>
To: N3FJPSoftwareUsers <>
Sent: Wed, Apr 15, 2020 4:05 pm
Subject: [N3FJPSoftwareUsers] Rig Control Issue with ICOM 7300

I want to use ACLog while working POTA. My COM10 is set at 115200, so I can use the N1MM Spectrum when contesting and it works well. I also use a program called VSPE and the virtual port is COM20 (not too important). I have the Baud Rate set with the "Other" at 115200. The Parity is None, Data bits 8 and Stop Bits 1. Connection power set to RTS like in N1MM. Mode determined by Rig and the Command to Read Frequencies is FE FE 94 E0 03 FD and the Command to Read Mode is FE FE 94 E0 04 FD. The rig keys and Polling Rig, however it does not read back the Frequency/Mode. If I click Frequency and send, it will QSY to that frequency. So I'm close, can someone give me some hint what I'm doing wrong?

73 Scott

Join to automatically receive all group messages.