Re: Ft 950 interface

Scott Davis
 

Hi Robb,

Thanks for your e-mail.  I'm sorry that you have run into trouble.  I'm not familiar with the Yaesu 950 myself, but I have had lots of good reports.  Typically, when the software is receiving frequency from the rig, the rig will also respond to commands.  Since it is not, and since it was working and then stopped without changing the software, it is very likely that whatever is at play is external to the software.  It could be your rig settings, your cable or your com port driver.

I'm sorry I don't have more in the way of specifics to suggest.  Perhaps someone more familiar with the 950 will have some ideas for you.

Good luck! 

73, Scott
N3FJP

Serving the Amateur Radio community with contesting and general logging software since 1997.

1 Peter 3 vs 15: Always be prepared to give an answer to everyone who asks you to give the reason for the hope that you have. But do this with gentleness and respect...


-----Original Message-----
From: Robb Zarges <RZarges@...>
To: N3FJPSoftwareUsers@groups.io <N3FJPSoftwareUsers@groups.io>
Sent: Sat, Mar 7, 2020 12:39 pm
Subject: [N3FJPSoftwareUsers] Ft 950 interface

hello,
My FT 950 rig has stopped sending to the N3JFP software but receives info from the software.  Any help would be appreciated. 

Thanks,

Robb Zarges, PhD
508-831-8248

Join N3FJPSoftwareUsers@groups.io to automatically receive all group messages.