Re: Winkeyer Emulator and RemoteRig RRC Query


Scott Davis
 

Hi Dennis,

Thanks for your follow up.  To change the Winkey settings in the software, click Settings > Transmit > CW.  Then click the Winkeyer button on the form that appears, but I doubt you need to change anything from defaults as Winkeyer isn't rig dependent..

Again, if you have your radio configured for keyer instead of straight key, it will not work.  You must have Winkeyer plugged into your straight key jack.

Good luck!


73, Scott
N3FJP

Serving the Amateur Radio community with contesting and general logging software since 1997.

1 Peter 3 vs 15: Always be prepared to give an answer to everyone who asks you to give the reason for the hope that you have. But do this with gentleness and respect...


-----Original Message-----
From: Dennis - WU6X <wu6x@...>
To: N3FJPSoftwareUsers <N3FJPSoftwareUsers@groups.io>
Sent: Mon, Nov 25, 2019 12:48 pm
Subject: Re: [N3FJPSoftwareUsers] Winkeyer Emulator and RemoteRig RRC Query

What it sounds like is that the macros are keying the radio and sending CW, but not distinguishing the difference between a dot or dash. Is there a software setting in the CW transmission settings I may need to change? Currently everything is set to defaults. 
Dennis WU6X 

Join N3FJPSoftwareUsers@groups.io to automatically receive all group messages.