Re: Issue with TQSL software path
toggle quoted messageShow quoted text
Thank you Scott for that link with the YouTube viewing.
Went back through, and this time used the "pull-down" tab for the station location and discovered that there was a "common" inserted in the middle where there should not have been! Now we are up and running a GREAT product.
On Fri, Aug 30, 2019 at 1:38 PM Scott Davis via Groups.Io <SNKDavisfirstname.lastname@example.org
Thanks for your e-mail. Choosing your station location in AC Log (that you have properly configured in TQSL) as detailed here will get you going:
Serving the Amateur Radio community with contesting and general logging software since 1997.
From: Larry Banks via Groups.Io <email@example.com
To: N3FJPSoftwareUsers <N3FJPSoftwareUsers@groups.io
Sent: Fri, Aug 30, 2019 12:53 pm
Subject: Re: [N3FJPSoftwareUsers] Issue with TQSL software path
From what I see from the message, you may not set up the locations in TQSL
Larry -- W1DYJ
Sent: Friday, August 30, 2019 12:33
Subject: [N3FJPSoftwareUsers] Issue with TQSL software
replaced my computer and successfully installed ACLog and the TQSL software;
however I am receiving Command Syntax Error (10) as the selection location
cannot be found? (see attached screen shot) Yet when I go and open directly the
TQSL program, uploading the log is not an issue.....I am running LoTW Manager
1.9 and ACL 6.5
Join N3FJPSoftwareUsers@groups.io to automatically receive all group messages.