Hi Guy's, Thanks to all who replied, I will keep N1MM for contesting and take a look at all that's been recommended. 73 Mike gm0phw www.dxmaps.co.uk

I locked the "what is the best non-contest logger?" thead. Members subscribed to this group for information about N1MM+, Off-topic posts dilute the usefulness of the group and lead some to unsubscribe

Is this N1MM logger only for contests? 73

i tried to use the gateway for the first time last weekend. I used the instructions to find the IPv4 address for my computer. It worked fine when tested; but did not work during the contest. Only thin

While running SO2R in RTTY mode in particular, is using the macro command {OTHERFREQ} considered self spotting and a no no? {OTHERFREQ} sends the frequency of the other radio where you are most likely

For the HamCation QSO Party, we worked with Les/G4OGB, Nick/NA3M, and Claude/VE2FK to work out a way for people to keep track of the nine HAMCATION 1x1 special event stations worked. We were grateful

I found during the contest that N1MM would not allow amplifier to change bands. I had to close N1MM, at which point I could hear a relay close/release. I then restarted N1MM and found that the amplifi

Hello Is it possible get spectrum scope with yaesu ft dx10, like flex 6700 and icom 7610?? Best Regards, Stein-Roar Brobakken post@... LB3RE K3RAG Skype: lb3re.rag

Hello Folks I had went for a comfort break at the weekend and on return I had started with the CQ and my tx audio was horrible, it was as if something was causing issues, I thought maybe RF getting ba

I noticed a new behavior in the Band Map and Available Mults window during the ARRL DX CW test. There were a number of times when I would work a spot but the spot would not disappear. If I tried to de

Is there a way to block the spotting of beacons, or at least the display of them in the available window? using an AR6 cluster.

I am looking for a Stream Deck Profile (15 buttons) which is made for N1MM in a SO2R setup. Is there anything existing around ? Thanks Roland

OK Ladies and Gents… I notice a different behavior than the past years with N1MM and N1MM+. I.E. many times I hit the enter (using ESM to start the exchange) before completing the callsign. As long as

I have two separate configurations/icons set up for my Icom 7300 and IC-705. I started the ARRL CW contest with my 705 bit decided to switch to my 7300. My contest log with several QRP contacts was ok

Ok, I installed the program then realised that some of the information was incorrect, mainly the log that I imported, adif file. Every time I uninstall and reinstall, it picks up the log, how do I tot

I’m sure I’m missing something, put is it possible to have two instances of n1mm rotor operate on one computer concurrently? (I’m hoping to use one to control the RX antenna, while the second does tx)

QSYing wipes the call & spots QSO in bandmap Is this adjustable somewhere? where you are in S&P and tune away and it clears the entry window, can this be changed and where/ Joe WB9SBD

When I open N1MM+, calls will begin to populate the grab window. However, when I select a call, work it, log, and then wipe it, no further calls will populate the grab window. Loaded Ver 1.0.8906.0 th

I installed CW GET and N1MM opens it but the decoded CW does not appear in the N1MM window, only CW GET window. Any idea what I did wrong? Tnx es 73 dit-dit

Yes! Steve is right. I don't what happened yesterday, after started 1mm+, it showed some error reports, then the program crash. I find the LogError.txt file in user\documents\n1mm logger+ folder, the