Anyone know where to find a printable keyboard overlay for N1MM+ ? Tks 73 F5VJC

Very Funny… Anyway, I got registered and active once again… I think the issue may have been a change of EMAIL from Terry.Glagowski@... to W1TR@... that caused this ! I’m working on

Hi Rich, Yes..CC User works extremely well with N1MM+ as a "front end" allowing the user with a graphical user interface to issue commands to the cluster you are connecting to. It works best with

Not necessarily. If you set the K3's CONFIG:PTT-KEY to RTS-DTR, you should be able to have the computer control PTT on RTS and CW on DTR, both on the radio control port, in which case you won't need

And, if you do that, I think you'll need VOX on in the K3. I did when I was keying with the RS-232 control lines. 73, Fred K6DGW - Northern California Contest Club - CU in the Cal QSO Party 1-2 Oct

Bjoern and Salvo, The user directory gets set on first installation (for the main user) or for any other Windows users at first run of the program. The program stores the location of the user

The buttons in the Telnet window are user-programmable. No single default set of cluster commands is going to make everyone happy. Ideally, users should study the command structure and syntax for the

See screen shot attachment. Sam WC7Q

How are you expecting it to send CW - that is, what method of CW keying are you planning to use, and how do you have it configured? A Winkeyer? Parallel port CW keying? Serial port CW on a separate

First, in the Configurer select SO2V to enable two VFOs and two Entry windows. Then, in the Config menu in the main Entry window select Sub Receiver Always On. 73, Rich VE3KI ---In N1MMLoggerplus@...,

Although CC Cluster nodes have been operational for 9 years, N1MM still does not have an option for selecting them. The correct command for showing filtered spots for both DX Spider and CC Clusters

I have downloaded N1MM+ and have set it up so that I have rig control....eg band changing and the programs follows the vfo of the K3. I am not able to get the rig to key up and transmit CW macros? All

A New release of the Super Check Partial database files is available at: http://www.supercheckpartial.com Calls in the MASTER.DTA file: 45,599 If you would like to contribute your CABRILLO format

Do not download and install version 3.23.05 of Fldigi. If you do it will no longer work with N1MM+. I have written Dave about this and it is also posted on the Fldigi group.. 73 Rick N2AMG

Arne, Turn off tracing. Tools, Program Execution Logging, Disable All. John, K3CT

This email must have come from an imposter. The real W1TR has already submitted 124 bug reports. ;) John, K3CT

Next problem My friend OZ2TF have just put his station together with N1mm Normally he is running wia Micro keyer MKII into a TenTec Orion II This setup is normmally running with dual VFO and

Hello to all Have a friend there are new to N1MM and not here on forum Have installed N1MM+ on 2 computers One is always coming with this message in startup " Tracind is turned on" Not seen

The bandmap normally labels your CQ Frequency as such, that is correct. It's a special designation so you can S&P and then bounce back to the same frequency again. All documented. 73, Drew K3PA

Hi Björn. May there are peoples than more than me have a direct experience on Parallels for Mac. I am using my 3 Macs natively in dual boot. BootCamp, no way to use Parallels here. :-( AFAIK there