SH/DX for many DX Clusters means give me unfiltered spots. If your own cluster filter is set too restrictive you may see few or no spots. SH/MYDX will give you spots that are run through your

In the Telnet window under the Filters tab, there is a button called "Help - Why don't I See Spots?" (you will probably have to scroll down to see the button). Have you read the message that comes up

I have to hit SH/DX in order to get new spots. After this, if I leave it for longer than the spot timeout, the bandmap is empty. What am I doing wrong?-- Dick - K4XU

Hi Hoe: Thanks. That was happening too...apparently triggering the error message. N1MM also prevented it by entering the frequency on the keyboard. Thanks, everyone. 73, Mark -- Sent from my

OK. I did a manual check and update release. Sometime in the last few weeks, I am not being told that there is a new release and whether I want to upgrade. I took that for granted and was not

1.0.5325.0 I am setup to get all new releases, or at least to ask. Rick NN4RB

Which release, Rick? I *think* this may have been fixed since that release. 73, Pete N4ZRDownload the new N1MM Logger+ at . Check out the Reverse Beacon Network at , now spotting RTTY

With the update to fix the WAE problem, I now find that when in RTTY mode the digital window stops if I click on an item such as the exchange and the left side changes to yellow. It will resume when

Make sure you have checked "Disable band lock (inband SO2R)" on the SO2R tab in microHAM Router for the micro2R. Otherwise micro2R will trigger a lockout. 73, ... Joe, W4TV

Yes - I don't have radios here. If the "big knob" works, I'll be fine when I get to the station. Thanks! 73, Mark

This occurred when you typed the frequency in the Entry Window, right ? The workaround is to use the big knob to set the frequency. 73, Steve, N2IC

Good day, everyone: I am setting up for the ARRL 10 meter contest - and trying more new things than I really should at one time: Microham u2r USB control protocol, u2r Winkeyer, and N1MM+!

Latest version working OK at CW5W. Dennis W1UE is operating the contest 73, Jorge CX6VM/CW5W De: N1MMLoggerplus@... [mailto:N1MMLoggerplus@...] Enviado el: domingo, 06 de diciembre de

Please tell me what contest would allow 2 receivers, separated by 700 km, to be used ? 73, Steve, N2IC

My 10 Meter contest score is showing 0 points for each contact although recording multipliers. I've tried to re-score but no help Any ideas? Tnx, Jim - W5AP

I ran into the same problem – frustrating. The solution is to just not enter anything in the exchange field unless the DX is not giving you a country. It might be better in future if N1MM would

Was the CW on the S&P QSO on the other radio okay while the Run radio was locked up ? If so, this is a K1EL issue. When you interrupt a CQ on Radio 1 to call someone on Radio 2, N1MM+ waits for

Try it without generating RF. RFI is a standard source of this sort of issue. 73, Pete N4ZRDownload the new N1MM Logger+ at . Check out the Reverse Beacon Network at , now spotting

I have two rigs. Radio 1 is connected to my laptop via Remoterig. The radio is located in Virginia and I am in Florida. In Florida there is a K3/0 that activates and controls a K3 in

Firmware version: 30.09 ---In N1MMLoggerplus@..., <n2ic@...> wrote : What version of Winkeyer firmware ? 73, Steve, N2IC