disabled com3, pc reboot requested: made.
Started microkeyer, say com3 will not work: right, it's disabled.
Enabled com3 from pc control panel (no reboot requested, no reboot made).
Run microkeyer, no messages about com3: right, it's enabled now.
Run N1MM, no "error opening com3" messages at startup, but if I put radio on cw and press a key where a message is stored, I still geto into a message like "error sending cw. check port selection in the configuration dialog.
And still no wav files are sent out.
Any other idea?
Marco - IK2XSL