Date
1 - 4 of 4
Mode selection #Bug #FSK441 #FT8
|
Andrew, ZS2PA
Hi all
When using MSHV in FFK144 I cannot change the mode say to FT8 unless I place MSHV into TX. I have to wait until the rig starts TX'ing then I can change the mode. Tried this with my Icom 7300 and FT897D. Your thoughts please Regards ZS2PA |
|
|
|
Anders, SM5EPC
For me it is not possible to switch from MSK144 to some other modes without to first Stop Monitor. In this case MODE is grayed out too. So try this: Stop Monitor - Change mode - Start Monitor. Good luck, SM5EPC Anders Den fre 28 sep. 2018 kl 08:54 skrev Andrew, ZS2PA <pride01@...>: Hi all |
|
|
|
Dave, G0CER <davekh@...>
Try - when Rxing set the Monitor button to off then try changing modes (then put monitor back on)? It might be something to stop a decode on one band being outputted on another if you quickly change bands. Dave G0CER On Fri, 28 Sep 2018 at 09:20, Anders, SM5EPC <sm5epc@...> wrote:
--
|
|
|
|
Hello,
same observation here. Sometimes it takes quite some time to change modes - in particulat to or from MSK/FSK. Changing modes from FT8 usually on the spot. I assume that once a decoding process has started it will be completed before a mode change is possible. Once you are aware, ist not a real problem. 73, DF5VAE PS: still hope to find one day an OMNI-Rig set-up option in MSHV - that would help many users. |
|
|