TBS 5927 setup
Terence O'Hanlon Smith
Good evening all,
having replaced my suspect SR1 Rx with a USB TBS-5927, I have carefully followed the Eumetsat setup guide for that receiver, and with all settings exactly as on page 12, I have obtained a signal strength of 75-80%, but at zero quality. I am reasonably sure all the associated Modcom and PID settings are correct, but obviously have no lock.
Has anyone any idea or experience of this, and of what may be amiss? (I believe I have the dish correctly pointed, but cannot be absolutely certain).
Thanks in anticipation,
This email has been checked for viruses by AVG.
David J Taylor GM8ARV 🏴 🇪🇺
On 25/09/2021 19:52, Terence O'Hanlon Smith via groups.io wrote:
Good evening all,Terence,
In case it helps, I have screenshots here:
and some background here:
The most common problem with the SR1 is bad power supply (Chinese), and
replacements are available from e.g. Amazon. Perhaps you've already been down
Most common reception issue is dish pointing.
SatSignal Software - Quality software for you